Packet Tracer Exploration: RIPv2 Basic Configuration Lab 7.5.1.2

This Packet tracer's network topology consists of three routers, four switches, and for hosts. First I cabled the network according to the chart and existing devices. For each router, I loaded the required scripts. I then examined the current status of the network by issuing the "show ip interface brief' command. I checked the connectivity between R2 and the hosts on the R1 and R3 lans. Afterwards, I checked the connectivity between the PCs by sending out several ping commands from one host to another. I then configured RIPv2 on each router. by issuing the command "router rip"then "version 2" right after that. I then verified that RIPv2 is running on the routers by using show ip protocol and show run. I then examined the automatic summarization of routes with the debug ip rip. Then, i disabled automatic summarization by using "router rip" command and "no auto-summary" right afterwards. I did that for each router. I examined the routing table again, and also checked the connectivity between the PC's again. After that, My completion rate from the Packet tracer activity was 100%. I learned how to cable a network according to the topology diagram, how to load scripts, examine routing updates with debug ip rip, disable automatic summarization, examine routing tables, verifying network connectivity, and how to document RIPv2 configuration