Packet Tracer Exploration: Convergence

In this packet tracer, I viewed the routing table of a converged network. I added a new Local area network to the topology. I learned how to view the debugging output. I finally watched the process of the network converging. First, I viewed the routing table for Routing table for Router2 and router 3. I then Documented the networks i learned from RIP. I then added a new LAN to the network topology by first adding a new 2960 switch and host to Router3. I Cabled the Switch from Fa0/1 interface to Router3's Fa0/1 interface. I then cabled the host to the fa0/2 interface on the switch.I then configured the appropriate IP addresses from the 12.0.0.0/8 addressing scheme for this LAN. I then Enabled the Fa0/1 interface on Router 3. I then Determined if the network has converged. I then turned on debugging on both routers. Afterwards, I was required to advertise the newly added network. THen I turned debugging off on router 2. I checked to see if the network has converged. In this lab, i learned how network converging works and how to actually set it up like that